Snap Ties are manufactured with integal heads, and metal or plastic form spreaders.
Snap Ties are designed to lock the Lumber or Plywood formwork easily. Snap Ties have a nominal 1" breakback. Each Tie incorporates an anti-turn device in order to properly break after use. Long End, Short End and Odd End Snap Ties for Plywood Formwork is available.
Wall Thickness | Weight(KG) | Packing |
6" | 0.093 | 100pcs/Carton |
8" | 0.103 | 100pcs/Carton |
10" | 0.113 | 100pcs/Carton |
12" | 0.123 | 100pcs/Carton |
14" | 0.133 | 100pcs/Carton |
16“ | 0.143 | 100pcs/Carton |
18” | 0.153 | 100pcs/Carton |
24“ | 0.183 | 100pcs/Carton |
Concrete form ties for plywood Snap Tie with 8-1/4" Long end: 6"-24" wall thickness
Wall Thickness | Weight(KG) | Packing |
6" | 0.128 | 100pcs/Carton |
8" | 0.138 | 100pcs/Carton |
10" | 0.148 | 100pcs/Carton |
12" | 0.158 | 100pcs/Carton |
14" | 0.168 | 100pcs/Carton |
16“ | 0.178 | 100pcs/Carton |
18” | 0.188 | 100pcs/Carton |
24“ | 0.218 | 100pcs/Carton |
The snap tie wedge is a holding device that is fabricated from high strength galvanized steel that is used in a double waler or double strong back snap tie forming application to ensure proper load distribution when installed correctly.
The snap tie wedge acts as a tie holder that slides vertically down the tie just inside the tie head drawing up all of the form components until snug. Horizontal double walers and/or vertical double strongbacks must be positioned within 5/8” – ¾” of either side of the Tie and the snap tie wedge must bear evenly. The tie end must end up at the midpoint of the wedge or slightly higher.
Other related items: Snap Tie Wedge, X Flat Tie, Wall Ties , etc.
https://www.form-scaffs.com/https://www.form-scaffs.com/